Griffon 2000TDX - 1/10 scale
Cut out two side panels (C). With reference to the dashed lines on the
drawing, mark out these lines in pencil on one side of one panel, and
on the other side of the other side panel. The side panel illustrated is the
right hand side panel.
Glue a 850mm long piece of 6mm square balsa strip to the outer bottom edge of each
of the two side panels (C). The outer side is the side without the pencil lines drawn on
it. Pin the strip in place, or hold in place with clothes pegs. Remove pins and pegs
when the glue is dry. Glue a 1060mm long piece of 6mm square balsa strip to the
outer top edge of each of the two side panels (C).
|
|
 |
| Side beams. |
|
Copyright © Mark Porter 1994, 2006