Griffon 2000TDX - 1/10 scale
Cut out two side decks (G). With reference to the dashed lines on the drawing, mark out
these lines in pencil on one side of one panel, and on the other side of the other side
panel. The side panel illustrated is the right hand side panel.
Glue a 110mm by 140mm piece of 6mm thick balsa sheet to the lower face of the two
side decks (G) at the forward and rear ends. Cut and sand to fit. The lower side is the
side with the pencil lines drawn on it. Add the strips and pin in place, or hold in place
with clothes pegs. Remove pins and pegs when the glue is dry.
|
|
 |
| Side decks. |
|
Copyright © Mark Porter 1994, 2006