Griffon 2000TDX - 1/10 scale
Make two cabin walls as shown in the drawing. One cabin wall goes at
the back of the cabin, the other goes at the front at the start of
the straight section of the cabin.
The cabin wall can be used to make templates for cabin frames. Cut
roof panels and side panels to fit the length of the cabin. The
cabin front is made by cutting two pieces of balsa to join the
forward edge of the cabin wall to join at the front of the craft.
These pieces must be made to fit your craft, so a drawing is
inappropriate.
The cabin should be made to be removable by ensuring that it is
not glued to the craft hull.
|
|
 |
| Cabin. |
|
Copyright © Mark Porter 1994, 2006