| Home | AP1-88/80 | AP1-88/100 | CC5 | Finger Trouble | Griffon2000TD | Griffon8100TD | SR.N2 | SR.N4 | SR.N5 | SR.N6 | SR.N6 Mk6 | BH.7 | SEDAM N300 |
The skirt is attached in two stages. The outer edge of the skirt is attached to the outer edge of the craft. The inner edge of the skirt is attached to the base of the craft.
Each panel has a long edge and a short edge. The long edge is attached to the outer edge of the craft. The outer edge has an overlap, or hem. This should be folded over and glued in place.
The side panel P3 is attached first. Note that panel P3 is made from panels P3a, straight section and P3b. Panel P1 at each end is fitted next. The P2 panels are then attached.
The inner edges should be tacked in place and the skirt inflated as a "trial fit". The inner edges may have to be slightly repositioned for best inflation.
The inner edge of panel P3 are glued along the bottom side edges of the centre box section of the craft. The end panels P1 are attached to the end edges of the box section. The remaining panels P2 fit between P1 and P3.